Advanced Search|Search Tips
Motor, 1/2HP, 1750RPM, 90VDC This motor is used on APACKS Conveyors & Cappers Use the E-PAK Part Number...
用于电梯前馈线,卡珀,转盘和时序螺钉
Used for electric power height adjustment of the 4 Station Capper.
电源高电机“运行盖”,每台115VAC 4站履带电源高度单元所需230 Vac 15 MFD(1087-040)
Power Height Motor "Run Cap", 115 VAC 50 MFD Required for each 115Vac 4 Station Capper Power Height unit (1087-038)
For DC motor control on cappers, conveyors, and similar machines. Board controls min/max and acceleration of motor speed range. Plug in resistors from 1/100 to 1 HP (see chart below). Horse Power Resistor is NOT included...
DC Motor Control Board Resistor Each KBIC Board needs a horse power resister, sized for the motor.
DC Motor Control Board For DC motor control on cappers, conveyors, and similar machines. Board controls min/max and acceleration of motor speed range. Plug in resistors from 1/100 to 1 HP (see chart below). Horse Power...
WELDMENT, JACK MT. STUD Used on power height jacks for cappers
管道,尼龙球1/8“高压用于脚脚销售的油脂系列
Gear Reducer, 5:1 56C Face Inline Used on 4 Station Cappers for the Spindle Motor * Do Not mix Lubricants in the reducer. If oil is needed, drain the gear box and replace all of the oil. Always check for proper oil...
Motor, 1/2HP, 40RPM, 90VDC Motor used on the 3 Station Cappers (Gripper Belt Drive) . Replacement oil for the Gear box: “Mobil Glygoyle Synthetic Gear Oil”, “Fully Synthetic Gear...
MOTOR, 1/2 HP 90V Used for a 3 Station Capper (Spindle Drive)
MOTOR, 1/2 HP 90RPM Used on 4 Station Cappers (Gripper Belts)
电机,1 / 2HP,1750RPM,90VDC电机驱动器,用于输送机和4站夹板,(有时3个STAION盖板)(主轴驱动器)。